Hammerwatch Forum

Custom mapping and Mods => Editor Discussion => Topic started by: Xeronkar on August 30, 2013, 12:50:59 PM

Title: Set a respawn point
Post by: Xeronkar on August 30, 2013, 12:50:59 PM

Hi,

I'm searching since lot of hours, but i can't find a solution. I want to set a respawn point on a map, without players have to see it before. Is it possible ?

For more explanations, i want to create an event, and if someone die, instead of respawn at the begining of the map, i want to respawn him in a cimetary, and the player have to wait all players to die, or one survivor finish the map. If everyone die, i reset the event, and if at least one survivor past the event, they can continue. With that, i could save lot of lives, and keep the Role Play.

Title: Re: Set a respawn point
Post by: Linaru on August 30, 2013, 06:08:59 PM

respawn points are set automaticaly when you walk over a checkpoint or when you enter a level. theres no other way to set them.

Title: Re: Set a respawn point
Post by: Xeronkar on August 30, 2013, 07:10:58 PM

Too bad, so i can't made my event...
Hope we can do it later :(